Atlanta Stud Welding

Studs

Heavy Duty

Wear Protection System

Arc stud welding is an excellent and reliable method of single sided fastening. Fasteners as large as 1 1/8" in diameter can be end-welded to a weldable base material in less than one second with the use of a solid state, transformer rectifier power source and a lightweight, portable stud welding gun. The time of the arc and amount of current to be discharged is measured by the controls built into the power source.

Stud Welding Equipment

New, state-of-the-art equipment from the largest manufactures in their field
Reconditioned equipment, guaranteed to perform at an affordable price
Production equipment for high-volume or close-tolerance requirements
Rental and lease equipment to meet the occasional jobs and requirements
Parts and accessories for all makes and models of equipment in the industry
Repair capabilities to keep your equipment running and jobs on-time

Single-sided fastening means:

There will be no air or liquid leaks
There may be no backside marking
Elimination of the cost of drilling and tapping holes
Means reduced labor cost and lower in-place cost

Arc Studs

Threaded and unthreaded flux loaded studs, size #10 to 1" Diameter
Materials include low Carbon Steel, various grades of Stainless Steel Aluminum, Inconel, Brass, and even Titanium
Shapes include round, rectangular and square


Concrete Anchors	Tapped Studs	Collar Studs	No Thread	Partial Thread	Full Thread

Lightweight

Capacitor Discharge Studs

Flanged & unflanged, threaded, unthreaded, tapped, knurled
Sizes from .100 dia. to .375 dia.
Materials including Mild steel, S.S., Brass, and Aluminum

For single-sided fastening to light gauge materials with minimal or no backside marking, CD stud welding is the answer.


Flanged	Non- Flanged	Drawn Arc	Non-Flanged No Thread	Flanged No Thread

Special CD Weld Studs

From a .060" diameter no-thread CD stud to a 7/16" hex CD stud, special CD studs can be manufactured to meet your precision fastening requirements. The illustrations below indicate just a few of the possible configurations in which CD studs can be manufactured. These illustrations, however, do not represent any standard product line. If you require a special configuration CD stud for your application, please submit a sketch or drawing with dimensions and material requirements for a quotation.